Installation Guidelines
The KEE Bio-Guard is supplied with the Motor disconnected.
Always plug in the Motor Connector before use.
The Bio-Guard Grease Digester
l
The KEE Bio-Guard unit is designed to automatically dispense enzyme based chemicals
into wastesystems to prevent the build up of fat and blockages in the drainage system. It
is battery operated for easy installation and can be programmed to dispense set volumes of
chemicals at set intervals to meet your requirements.
Installation
l
Locate the Bio-Guard dispenser as close to the chemical container as possible, ideally
within 5 meters. Try to avoid exposure to direct heat, moisture or steam.
l
The unit is already fitted with wall fixing brackets and is supplied with the necessary fixing
screws and raw plugs for installation.
l
The unit is also supplied with 4 meters of pvc tubing and a tube support. The tube support
end of the tube should be placed in the chemical container and the other end connected to
the inlet connector of the Bio-Guard pump.
(NB: Warming of the PVC tube will assist in fitting it to the Inlet connector. Shown by
arrows on pump face).
l
Any excess PVC tubing can be used to connect from the outlet connector to the waste pipe
or grease trap. An adjustable pipe connector is also available from KEE Services Limited if
required.
Batteries
l
The KEE Bio-Guard is supplied with a self contained battery pack, which should provide at
least 12 months operating life based on standard usage.
l
To change the battery, start by removing the lid.
(unscrew the 4 plastic screws, one in each
corner)
.
l
Then disconnect the battery pack by removing the small white connector with a red and
black wire.
(see diagram on page 3)
.
l
Remove the old battery pack, fit the new pack and plug in the connector.
Priming
l
Press the ‘PRIME/TEST BUTTON
’ on the underside of the unit to fill the tubing with chemical
and to test the pump.
Summary of Contents for Bio-Guard
Page 1: ......
