4
e, make a mark on edge of detected object through the marker aperture by
detected
utton released incautiously, you must restart the calibration and repeat the
teps above to detect.
ation requirements for AC live wire detection, calibrate the tool
ark with
rough walls”.
c.
The center of the two marks is just the center of AC live wire.
pipes or metal covered wire, as well as metal walls or walls of high
bration requirements for metal stud detection, calibrate the tool to
e to the method of “Wood stud detection---detecting wood joists through
.
The center of the two marks is just the center of metal stud.
when moving, reset automatic calibration and detection from another place).
c.
If the edge of joists are detected, the center light will illumine and the beeps will rings,
at this tim
pencil.
d.
Repeat the steps above from the opposite direction to detect the other edge of the target
object and make a mark; the center of the two markers is just the center of the
object. Repeat the operations for several times to get the relatively precise result.
Notice:
if the power b
s
B.
AC live wire detection---detecting the AC live wire through walls
a.
According to the calibr
to the ideal induction.
b.
Operate the tool and find out the two edges of AC live wires and make a m
reference to the method of “Joists detection---detecting joists th
Notice:
AC live wires in metal
density all cannot be detected.
C.
Metal object detection---detecting the metal stud through walls
a.
According to the cali
the ideal induction.
b.
Operate the tool and find out the two edges of metal studs and make a mark with
referenc
walls”.
c
TIPS ON OPERATION
z
tion: please replace the battery when abnormal calibration or
e scanner.
z
operation and keep the other hand at least 6 inches away from the tool during detection.
er of the target object, but the width of the target
t place.
ct the slate or mixed plate correctly because the
the wall, ceiling or floor, please take care to the
ines, CATV wires and circuitries without
e space between joists is 16 or 24
n is not suitable for metal wall or the metal materials in the wall distribute
J.
When constructing beside the AC live wires, the power supply should be switched off.
Using new battery
Check the battery before opera
no response occurs on th
Recommendation
In order to make sure that the scanner is on the best state during detection, hold the tail of the
tool when
z
Tips
A.
The tool can accurately detect the cent
object can only be detected in a range.
B.
Please do not use the tool near strong electric wave.
C.
Please do not use the scanner in high temperature and we
D.
Please try to avoid using the tool on wet plate and wall.
E.
Sometimes, the scanner cannot dete
density of the materials change a lot.
F.
When tacking, cutting or drilling on
wires and pipes on the back of them.
G.
The covered wires, useless wires, telephone l
electricity could not be detected as live wires.
H.
When the thickness of detected wall is over 3/4 inches or the joists are close to each
other, joists detection is not suitable, generally, th
inches, and the width of the joist is 1 to 1/2 inches.
I.
The detectio
too thick.