OPERATION INSTRUCTIONS
z
Battery Installation
Open the battery cover E, insert the battery with correct polarities, close the battery
cover
。
z
Search for metal
Set the switch C to Metal, operated as the following steps:
1
、
Place the detector with the head A against the wall, keep pressing the power button D,
then the indication light turns dark light. This will set the measurement at the right level of
sensitivity.
。
2
、
Keep moving the head A slowly, when close to the metal objects, the indication light
will twinkle and with buzzer sounds. At this moment, please slow down the pace, then the
frequency of indication light and buzzer will turn faster at the same time.
3
、
Release the button D and press again to set the sensitivity for another time. If the light
shines and the sounds out no matter move to any point or leave this point, it means the metal
is present where the buzzer sounds.
4
、
Repeat the above steps, and power on again when the indication light twinkles to set
the sensitivity. Then do detecting for several times to get more exact place.
z
search for AC Live Wire
Set the switch C to Wire, please refer the steps for searching Metal.
z
Notice
A
、
Set the mode switch before it is power on for detecting. At the beginning, the detector
will set the sensitivity no matter if the objects exist or not. If there is no objects or the
objects are far away, the detector will set to the strongest sensitivity automatically.
B
、
Please check the battery before operation. If the detector doesn’t work well, please
3