10
KEBBY INDUSTRIES
STEP 1: Disconnect the air supply from the Gauge/Regulator Assembly.
STEP 2: Loosen the thumb-screw and slide the hinged cover back on the
Crimp Stand Assembly.
STEP 3: Swing the hinged cover open on the Crimp Stand Assembly.
STEP 4: Align the Power Crimp with the Crimp Stand and slide the Power
Crimp down and into the Crimp Stand Assembly.
STEP 5: Hold the Power Crimp in place and swing the hinged cover closed.
Finger-tighten clamp thumb-screw.
STEP 6: Install the verification nut onto the Kebby Power Crimp adapter. Hold the
1 /2” wrench stationary and tighten the nut using a 9/16 open-end wrench.
ASSEMBLE POWER CRIMP TO CRIMP STAND
FIGURE 1-5
ASSEMBLY
Summary of Contents for A10001
Page 2: ......
