5
Configuration
General information
A Kemro system needs data for the configuration of system performance, its
I/O-devices and interfaces. The system reads this data during the start-up op-
eration and allocates them to its components and devices.
Configuration data is created by included configuration tools or by editing con-
figuration files.
For further information to the configuration see the documentation of the in-
cluded configuration tool.
For further information to the configuration see the documentation of the in-
cluded configuration tool.
5.1
Setting the K-Bus address
The module is addressed via the address switch. A maximum of 12 modules
of the same type can be distinguished on one line.
The address switch is located on the right side underneath the lower cover (the
K-Bus plug is located underneath the upper cover).
Fig.5-1:
Position of the address switch
1
... Address switch
On leaving the factory all modules are set to address 0 and both covers are
closed.
Information
Modules of the same type that are installed within the same line must have
different address switch positions. Different modules (e.g. analog and digital
modules) may have the same address switch positions.
TM 225/A
Configuration
© KEBA 2011
Project engineering manual V1.06
17
Summary of Contents for Kemro TM 225/A
Page 4: ......
