KE LOGEM LGH 28.8D1, Operation Manual, Page: 99 / 200

99
Operation Manual V.34 - Modems, Version 07/97
AT
Chapter 3
The connection is being deestablished after typing the new calling number.
Now the modem generates the dialing command ATD05116747590 and
initiates the dialing procedure.
The callback number defined in Z9 will not be altered by this procedure!
The standard callback number should be stored in the short dial register
for this reason!
If the new callback number starts with a „ . “ (point) the calling number
does not begin with a dialing prefix. This feature is important for calls
inside the PABX system to suppress the central office access.
Additional information operation mode C:
If you do not type a callback number for operation mode ZC (AT&Z(n)=ZC/
PASSWORT) the modem prompts for a callback number after password
request.
General information:
• If you type a password without a callback number the prefixed
„/“ is very important.
• If a number storage does not contain any operation mode label
and no callback number the modem connects directly to the
HOST if a valid password is being entered.
• After dial up to a password protected modem the subscriber is
prompted with „Passwort“ to enter a password. The connection
will be deactivated:
- if you do not enter a valid password after 3 minutes or
- if 3 invalid passwords have been entered.
• A HOST connection is established after typing of a valid password
or if a successful callback is reported (DCD is active)
• At password protected operation the RING report and the state
of the interface line RI (M3) are not transfered to the HOST. If you
need these reports nevertheless refer to register 102.
AT Commands