KDF Plus Series, Instruction Manual

Page: 18 / 31

16
Program mode
・
Press the "F1" (program) key in standby mode to switch to this mode.
In this mode, each operation can be programmed.
◆
Explanation of main display
・「－」
display
：
Indicates the unprogrammed status.
・
Yellow frame
：
The cursor position. You can change the values in this frame.
◆
Explanation of operation keys
・
F1
（
Return
） ：
Return to standby mode.
・ F2 （ Multi ） ： Used in combination with the arrow keys when inserting, deleting, moving left and
right pages, etc.
・
F3
（
UP
） ：
Increases the set value.
・
F4
（
DOWN
） ：
Decrease the set value.
・ Up/down/left/right direction ： Moves the cursor (yellow frame).
・
START
／
STOP
：
Copies the segment contents on one line.
◆ Programmable value range and description of each item
Item name Input range Outline Initial value
Pattern
name Character
：
English (uppercase) number
Number of characters
：
16 single-byte characters
Input the pattern name
Enterable symbols
[:] [=] [>] [<] [-] [.] [+] [/] [～]
Blank
Temp. 0 to 1150
℃
(other than 5000Plus)
0-1100
℃
(5000Plus)
Segment set temperature
0
℃
Time 0:00 to 99:59 (hour:min.) Segment set time 0 ： 00
PID group 0-9, A PID group selection, A is auto A
SS 0-99 ℃
0 is no SS operation
Soak stop set temperature
Set the temperature range when you want to
give priority to temperature. Does not move to
the next segment until the current temperature
falls within this width. 0 ℃
♪
(Buzzer)
0 to 5
0 means no buzzer sound Notification when moving to segment Buzzer
Buzzer sound that sounds at the end of the
segment can be set from 5 tones 0
Gas1, Gas2
EV1,EV2
EV3, EV4
(Each ON/OFF)
--:-- and
0:00-99:59 (hour:minute)
※ --:-- is not set.
Each ON time and OFF time of gas 1,2 and
EV1-4
※ An optional gas introduction unit is required to flow
the gas.
--:--
Press and hold to change at high speed.