KBS QN-600, Instruction Manual

Page: 15 / 98

13 P2M058STD-Ver1.0
GB
Troubleshooting
Fault Potential Failure Problem solving action
The appliance is not
working The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug and/ or lead are damaged Call your agent or qualified technician
Fuse in the plug has blown Replace the fuse (UK Plug)
Power supply Check power supply
The appliance turns
on, but the
temperature
is too high/ low Too much ice on the evaporator Defrost the appliance
Condenser blocked with dust Call your agent or qualified technician
Doors are not shut properly Check doors are shut and seals are not
damaged
Appliance is located near a heat
source or air flow to the condenser is
being interrupted Move the refrigerator to a more suitable
location
Ambient temperature is too high Increase ventilation or move appliance to
a cooler position
Unsuitable foodstuffs are being
stored in the appliance Remove any excessive hot foodstuffs or
blockages to the fan
Appliance is overloaded Reduce the amount of food stored in the
appliance
The appliance is
unusually loud Loose nut/ screw Check and tighten all nuts and screws
The appliance has not been installed
in a level or stable position Check installation position and change if
necessary
The appliance is
leaking water The appliance is not properly leveled Adjust the screw feet to level the
appliance (if applicable)
The discharge outlet is blocked Clear the discharge outlet
Movement of water to the drain is
obstructed Clear the floor of the appliance (if
applicable)
The water container is damaged Call your agent or qualified Technician
The drip tray is overflowing Empty the drip tray (if applicable)