2-PHASE OPERATION
The wiring for 2-phase operation is shown below.
Re-wire the 3 cables according to the diagram. Make
sure that you use the right cable for the power sup-
ply.
K1.1
K1.3
K1.5
gnd
L1(R)
L2(S)
L3
L2
L1
PE
B
C
D
7
6
5
4
9
8
1
2
3
change connections
from[X0.L3D]to[X0.L2C]
from[X0.L1C]to[X0.L3D]
2
3
remove connections
from[X0.6B]to[X0.L2C]
1
jumper
Wago 2016-402
KBL 3200453520
Wago 2006-402
KBL 3200463040
set jumper settings
1x 220V / 50Hz ~ (10 mm²)
Connecting an external timer
Connect the external timer (e.g. coin box, studio
control) according to the instructions supplied with
the timer. The following diagram shows the wiring of
the timer connection. A door contact is necessary for
the option “cabin fragrance”.
connection timer
PE
L
1
2
N
3
4
5
remote start
enable
connection to the coin box/external timer
6
door contact
Connecting an external audio source
The cinch marked in the illustration is connected to
the external audio source where the line-out of the
sound player or the headphone/loudspeaker jack are
available for connection.
Operation using different
audio sources
The tanning unit can be operated using the following
audio sources:
•
An internal audio source
•
Various external audio sources
•
All available audio sources
The audio source can be changed via the control
panel.
INTERNAL MP3 PLAYER
When using the internal MP3 player, you can either
play the music tracks that are originally supplied on
the SD card, or you can record your own tracks to
the SD card.
EXTERNAL AUDIO SOURCES
- LINE IN
As an external audio source, you can connect
devices ranging from the standard-line level to low
loudspeaker levels.
These sources comprise:
•
Studio music
•
External players such as MP3 players, mobile
phones (cell phones), I-pods, etc.
B r u k s a n v i s n i n g
|
Tower Optima
11
