O p e r a t i n g I n s t r u c t i o n s
|
megaSun space 2000
40
Interior unit lighting
LED - UNIT LIGHTING
If the tanning device is lighted by means of high-per-
formance-LED‘s, these can only be replaced by a
qualified specialist if they are defective. In this case,
contact the service department!
CONVENTIONAL UNIT LIGHTING
4
If the tanning device is lighted by means of fluores-
cent lights, proceed as follows:
TOP CROWN
• Undo the two screws at the facing of the “Tower
lighting in top crown” and remove the facing.
4
• Turn the lighting tube a quarter turn towards the
front and take it out towards the front.
• Replace the lighting tube and, if present, the colour
filter.
• Fasten the facing again.
DOOR
• Place a suction cup in the centre of the respective
pane and slowly pull the pane towards the front.
• Loosen the pane at one corner and go on down-
wards, then pull the pane off.
Caution!
Place the door panel carefully on a pad-
ded surface.
There is one decorative tube beneath the door panel.
Turn the tube a quarter turn to the right and take it
out towards the front. Replace the tube, the colour
filter (if present) and the starter. Fasten door panel
again.
Summary of Contents for megaSun space 2000
