KBL megaSun 8000 a Hybrid, Assembly Instructions Manual

Page: 13 / 68

A s s e m b l y I n s t r u c t i o n s | 7000
α
/8000
α
touch
13
• Move the complete bed pane slightly to the left so
that the right pin is also free.
4.4.3 LIFT OUT BED PANE
• Grab hold of the bed pane on both sides and lift it
up to the maximum height (20 mm distance to the
canopy) and lift it out of the rear guide profile in
this position .
Be careful when removing the bed pane.
When the bed pane is lifted out, it can
bump against the canopy.
• The distance between canopy and bed
pane may not be less than 20 mm.
20mm
• Transport the bed pane to the installation site and
set it down safely on protective padding.
4.5 Remove front panel
PH2
4.5.1 INSTALL CANOPY PANE (TEMPORARILY)
Safety measures to protect the tube
section of the canopy.
• Make sure that the control panel cable is
not caught or pinched.
4.5.2 REMOVE SIDE PANELS – 7900/8000
α
• Pull the two acrylic panels of the decorative lighting
of the bed out to the sides.
4.5.3 OPEN THE BED
4.5.4 REMOVE FILTER ELEMENT (RIGHT)