B r u k s a n v i s n i n g
|
megaSun 4800
11
The wiring for 2-phase operation is shown below.
1. Remove wires
ⓐ
(3 x Ø2,5mm x 0.1m).
2. Set jumper
ⓑ
(2 x Wago 2016-403).
3. Connect the 2-phase mains supply (PE-L1-L2)
according to the diagram.
4. Make sure that you use the right cable for the
power supply (see table “Technical data”).
2-Phase Operation
(2 x 220V / 50Hz)
PE L1
L2
ⓑ
Connecting the external timer
Connect the external timer (coin box, studio control)
according to the instructions supplied with the timer.
The following diagram shows the wiring requirements
with regard to the timer. The door contact is required if
you have opted for the booth-scenting feature.
Connecting an external audio
source
When connecting an external audio source (studio
music), pay attention to the correct polarity.
Level adjustment studio music
signal
The voice / audio system components are built in
the middle of the bench part (vacuum housing) of
the sunbed. The potentiometer which serves of
the external audio signal is located on the left side
of the housing. To avoid overdrive, select the level
adjustment accordingly. The level setting depends
on the strength of the external signal and should be
carried out by a service engineer. Adjustment of the
sound level can only be conducted in the service
menu.
Summary of Contents for MegaSun 4800
