18
Operation and Service megaSun 4500
3.6.
Unit lighting
Coloured fi lter
Replacing the
lighting system in
the lateral part and
in the base part
The coloured
fi
lter has to be replaced at the latest when repla-
cing the tanning tubes.
One tube (8 watts) each is installed in the side frames (see Fi-
gure 3-6-2), another tube (58 watts) is installed in the lower front
section (see Figure 3-6-3) and in the canopy‘s front there are
two 42 W compact
fl
uorescent lamps.
Fig. 3-6-1 Fixing screw at the interior
lateral covering
Fig. 3-6-2 Lighting tube in the lateral part,
including starter
Starter
Step
Procedure
Reference
1
Side frames:
Undo the screw
fi
xing the interior lateral
panel. Remove the panel and the coloured tube covering.
Now you may replace both tube and starter.
Fig. 3-6-1 and
Fig. 3-6-2
2
Re-install all parts in reverse order.
3
Bench:
The lighting tube is installed behind the front pro
fi
le
and may be easily exchanged. The starter is located at the
left-hand socket.
4
Canopy
Take off one of the chromed faceplate which is fastened
with hook and loop tape.
Unscrew the the mounting plate‘s four screws and
remove the mounting plate.
Pull out the illuminant carefully. While replacing it, see
that the connector is in the correct position.
Attach the mounting plate. See that the edge of the
dispersion plate is beneath the mounting plate. Attach
the chromed faceplate. Repeat the procedure on the
other side.
•
•
•
•
Fig. 3-6-4
Fig. 3-6-5
Fig. 3-6-6
Fig. 3-6-7
