18
Operation and Service KBL 4000/4500
3.6. Unit lighting
Coloured # lter
Replacing the
lighting system in
the lateral part and
in the base part
The coloured fi lter has to be replaced at the latest when repla-
cing the tanning tubes.
One tube (8 watts) each is installed in the side frames (see Fi-
gure 3-6-2), another tube (58 watts) is installed in the lower front
section (see Figure 3-6-3) and in the canopy‘s front of the KBL
4500 there are two 42 W compact fl uorescent lamps.
Fig. 3-6-1 Fixing screw at the interior
lateral covering
Fig. 3-6-2 Lighting tube in the lateral part,
including starter
Starter
Step
Procedure
Reference
1
Side frames:
Undo the screw fi xing the interior lateral
panel. Remove the panel and the coloured tube covering.
Now you may replace both tube and starter.
Fig. 3-6-1 and
Fig. 3-6-2
2
Re-install all parts in reverse order.
3
Bench:
The lighting tube is installed behind the front profi le
and may be easily exchanged. The starter is located at the
left-hand socket.
4
Canopy (KBL 4500)
• Take off one of the chromed faceplate which is fastened
with hook and loop tape.
• Unscrew the the mounting plate‘s four screws and
remove the mounting plate.
• Pull out the illuminant carefully. While replacing it, see
that the connector is in the correct position.
• Attach the mounting plate. See that the edge of the
dispersion plate is beneath the mounting plate. Attach
the chromed faceplate. Repeat the procedure on the
other side.
Fig. 3-6-4
Fig. 3-6-5
Fig. 3-6-6
Fig. 3-6-7