kbice FDFM1JA01, Service Instructions Manual

Page: 4 / 30

4
4
i n f o @ f l u r i d a a p p l i a n c e s . c o m
 Fill the water reservoir with 12 teaspoons of food grade citric acid
powder.
 Wait for a few hours and plug the unit into power again.
3-If the Clean LED flashes quickly and the unit stops making ice (If
this section can’t solve your problem, please go to section 8 or check
your installation clearances and ambient temperature)
 Empty the ice bin and water reservoir following instructions in Section 2.
 Fill the water reservoir with clean potable water to MAX WATER FILL.
 Plug the unit into power. You will hear 5 beeps if the reservoir is full.
 Press and hold the Clean button for 3 seconds to start the cleaning cycle
for defrosting process. The Clean LED will start flashing slowly (it takes
30 minutes to complete and the Clean LED goes off).
 Press the Make Nuggets button once to start making ice.
4-If all LEDs flash simultaneously and water is filled to MAX WATER
FILL
 Drain water following instructions in Section 1.
 Fill the water reservoir with clean potable water to MAX WATER FILL.
 Plug the unit into power. You will hear 5 beeps if the reservoir is full.
 Disconnect the UR tube connector for 5 seconds to release air and
reconnect it again.
5-If the Make Nuggets LED illuminates but the unit has dispensed all
ice
 Press and hold the Dispense button for more than 30 seconds to restart
making ice.
6-If ice is jammed at the dispense point and the unit can’t dispense ice
 Remove the jammed ice in the dispense point with a teaspoon.
 Or break the jammed ice by pressing the Clean button while you hold
the Dispense Nuggets button .
 Then press and hold the Dispense Nuggets button to dispense ice.