9
6.
The 4 Pin Deutsch connector has been supplied with a mating connector. Be sure to
follow proper wire schemes as identified in the diagrams.
7.
The supplied DPST switch will be installed in addition to or paralleling the existing key-
start switch. Locate and install the DPST switch in a convenient location relative to
the key switch.
4.2 Mounting the KSM Unit
Using the dimensions shown in Figures 3, and 4, use four (4) ¼” bolts, nuts, and lock
washers (not supplied) to mount the KSM unit to vehicle, vessle, or equipment chassis
.
If
mounting on a soild bulkhead or other location without backside acsess, other fastiners such
as suitably-sized tapping screws can be used.
When selecting a location for installation, make sure that the KSM module and cables will
clear any hoods, hatches, lids, covers, and other movable vehicle, vessel or equipment
parts. Avoid locations that are subject to extreme heat, dripping water, humidity, road dirt,
ice, and snow. While the KSM unit may be mounted in any position or orientation, do not
mount it directly over batteries, or under ventilation systems through which water might
drip. The internal components of the KSM are IP67 rated, but the KSM itself is not IP
rated. Take care to prevent the external case of the KSM module from receiving any
physical impacts.
CAUTION
Summary of Contents for KSM
