Kaysun Prodigy Series, Owner'S Manual

Page: 9 / 20

Fig. B
Deflector
rod
The louver can be taken
down by releasing the
lock block
Fig. A
Range
 Page 9 
• Setting Angle of Air Flow
Setting vertical angle of air flow
While the unit is on, use the
SWING/DIRECT
button to set
the direction (vertical angle) of airflow.
1. Press the
SWING/DIRECT
button once to activate the
louver. Each time you press the button, it will adjust the
louver by 6º. Press the button until the direction you
prefer is reached.
2. To make the louver swing up and down continuously,
press and hold the
SWING/DIRECT
button for 3
seconds. Press it again to stop the automatic function.
(The vertical louver auto swing is an optional function).
Setting horizontal angle of air flow
The horizontal angle of the airflow must be set manually.
Grip the deflector rod (See
Fig. B
) and manually adjust it to
your preferred direction.
For some unit the horizontal angle of the airflow can be
set by remote control. Please refer to the
Remote-Control
Manual
.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set louver at too
vertical angle for long periods of time. This can cause water
to condense on the louver blade, which will drop on your
floor or furnishings (See
Fig. A
).
When using COOL or HEAT mode, setting the louver at too
vertical angle can reduce the performance of the unit due
to restricted airflow.
Do not move louver by hand. This will cause the louver to
become out of sync. If this occurs, turn off the unit and
unplug it for a few seconds, then restart the unit. This will
reset the louver.
CAUTION
Do not put your fingers in or near the blower and suction
side of the unit. The high-speed fan inside the unit may
cause injury.