13
Air return flange
Step 4: Adjust the air inlet direction
(From rear side to under-side.)
1.
Take off the ventilation panel and flange.
Step 5: Fresh air duct installation
Dimension:
Duct joint for fresh air
Fig. 4.11
2.
Change the mounting positions of the
ventilation panel and air return flange.
Ventilation panel
Fig. 4.12
Fig. 4.14
Step 6: Motor and drain pump maintenance
(the rear ventilated panel is used as an example)
Motor maintenance:
1. Take off the ventilated panel.
2. Take off the blower housing.
3. Take off the motor.
3.
When installing the filter mesh, fit it into the
flange as illustrated in the following figure.
Fig. 4.13
Pump maintainance:
Mofor
Blower housing
Ventilated panel
Fig. 4.15
1. Remove four screws from the drain pump.
2. Unplug the pump power supply and water
level switch cable.
3. Detach the pump.
Fig. 4.16
Air return flange
NOTE:
All the figures in this manual are for
demonstration purposes only. The air conditioner
you have purchased may be slightly different in
design, though similar in shape.
MODLE
18-60
Ø125mm(4.92”)
Ø160mm (6.3”)
Summary of Contents for KPD-105 DTN11
Page 36: ...36 It comes from page 22 ...
Page 40: ......
