Controller installation place
Wired
controller
03
●
Make sure that the water discharge pipeline can provide
smooth drainage. Improper installation of the water
discharge pipeline may lead to water leakage, and
damages to furniture.
●
Make sure the liquid pipeline and air duct are reliably
supported. Make sure pipes and connectors are not
distorted.
●
The water inlet and outlet pipes must have check valves
installed and be wrapped with insulation materials.
●
Connect the wires as required. Otherwise, it may cause
damage to electrical parts.
●
The actual power supply must be consistent with the
nominal nameplate value, or permanent damage may
occur.
●
Use power cord with a proper diameter.
●
Do not use damaged cables. Replace the damaged
cables immediately if necessary. Do not attempt to
repair the damaged cables.
●
Keep for future reference.
2.4 Information
●
Keep the unit serial number available for future
reference and in case when you need to contact the
after-sales service.
●
Do not bring any combustible materials near the air
outlet.
●
Transport the unit as per requirements indicated on the
package.
●
Avoid crash, fall-over or squeeze and keep away from
rain and snow during transportation.
●
Store the unit in a clean, dry, fire-proof and well-
ventilated place without any corrosive gas.
●
To avoid shock during transportation, fix the unit and its
accessories on the transportation platform with ropes or
by other means.
3 OPERATION INSTRUCTIONS
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by
children without supervision.
●
The manufacturer is not responsible for unit damages or
personal injury resulting from unauthorized operations
or use of non-original parts or accessories.
●
Ventilation
Periodically ventilate the room where the unit is
installed. Ventilation is especially important in case the
room has many people in it or has flammable devices
or gas sources. Poor ventilation may result in lack of
oxygen.
- Before unit operation, clean water pipes to prevent
them from being blocked.
- Upon FCU test run or switching between hot and cold
water, open the vent valve to exhaust air in the coil
until water flows out. Otherwise, the heat exchange
performance may be significantly compromised.
●
During operation
Filter is normally not removed except for maintenance
purpose, as doing so may cause foreign objects to enter
the unit.
●
In normal cases
In cooling mode, fog may appear at the air outlet.
Figure 3-2 After installation of wired controller
Figure 3-1 Installation position of wired controller
3.1 Standard Conditions for Use
Use the system in the following temperature for safe and
effective operation.
Mode
Indoor temperature
Cooling
17-32°C
Heating
0-30°C
If air conditioner is used outside the above conditions,it
may cause the unit to function abnormally.Optimum
performance will be achieved within these operating
temperature range.
The unit can only operate normally as long as you
strictly adhere to the regulations outlined in the Manual.
Water inlet temperature range is 3-75°C.
Water inlet temperature range recommended is 3-65°C.
Water inlet pressure range is 0-1.6MPa.
3.2 Switch and Control
The wired controller should be purchased separately
from the manufacturer. Other wired controllers are not
applicable.
Installation position of wired controller
You can install the wired controller on the left, or right of
the unit or on the wall as required. Make sure the wired
controller is close to the electric control box.
Please refer to the Wired Controller Operation and
Installation Manual for installation methods.
Summary of Contents for KFC-S2E-2T-250D
Page 22: ......
