2
2
1
1
Casing
assembly
1
1
1
1
2
2
1
1
Base
Footing
Base
Structure the square rod on the beam to set the lifting
bolts.
Directly set and use an angle steel for support.
Use embedded bolts, and pull bolts.
Wood structure
Steel framework
Suspension bolt
Suspension bolt
Angle steel
for support
Knife-type
insertion piece
Sliding-type
insertion piece
Reninforced bar
Embedded bolt(hanging and
embedded bolt of piping)
09
Original concrete slasb structure
Newly set concrete slab structure
Figure 5-1
Mark the places for screws on the wall according to the unit
mounting holes or dimensions specified in Figure 5-12. The
drain pipe for condensate water must be smooth enough to
allow unobstructed water discharge.
As shown in Figure 5-2, fasten four screws (
①
) into a
proper masonry structure.
Figure 5-2 Diagram for fixing the unit body
The footings shown in Figure 5-3 are optional. You can
purchase them separately and install them as follows:
1. Put the footings beside the unit to be installed.
2. Place the mounting holes on the unit base into the
corresponding footing locating pin and install screws
①
*2
and
②
*2 to fix the footing according to Figure 5-3.
Figure 5-3
3) Install the unit following the steps below in case it
is ceiling mounted.
To match the existing structure, set the screw pitch
according to the unit dimensions.
Figure 5-4 Installation of lifting bolts
Set using embedded appliances, and embedded type
of bolts.
Summary of Contents for KFC-S2E-2T-250D
Page 22: ......
