background image

  

 

Do  not  place   appliances  which   produce  open  fire   in  
places exposed to the air flow from the unit or under the  
indoor unit.

   

It may cause incomplete combuston or deformation of the unit  
due to the heat.  

Use the system in the following temperature for safe and  
effective operation.  

Do  not  install  the  air   conditioner  at  any  place  where  
flammable gas may leak out.   

If the gas leaks out and stays around the air conditioner, a fire  
may break out.   

Temperature  

Outdoor  

temperature  

Room  

temperature  

water inlet  

temperature 

Mode  

Cooling operation  

0°C

43°C 

17°C

32°C 

0°C

30°C 

3°C

20°C 

The  appliance  should  not  be  used  by  children  without  
supervision.  

Heating operating 

(cooling only 

type without) 

-15°C

24°C 

30°C

75°C 

DISPOSAL

Do not dispose this product as unsor-  

ted municipal waste. Collection of such waste sepa-  
rately for  special treatment is necessary.  

NOTE  

1  

2  

If air conditioner is used outside the above conditions, it  
may cause the unit to function abnormally.  

Do not dispose of electrical appliances as unsorted municipal  
waste, use separate collection facilities.  

Contact you  local  government  for  information  regarding  the  
collection systems available.  

The  phenomenon   is  normal   that  the   surface  of   air  
conditioning   may  condense   water  when  the   relative  
larger  humidity   in  room,  please   close  the  door   and  
window.  

If electrical appliances are disposed of in landfills or dumps,  
hazardous substances can leak into the groundwater and get   
into the food chain, damaging your health and well-being  

3  

Optimum  performance   will  be  achieved   within  these  
operating temperature range.  

 

In heating mode,the temperature of the inlet water must  
be  under 75

℃.  

The air conditioner consists of the indoor unit, the outdoor unit,  
the connecting pipe and the remote controller.  

Water  system  operating  pressuer:  Max:  1.6MPa,  Min:  
0.15MPa.   

Function indicators on indoor unit display panel  

Temporary button 

Frost indicator  Infrared signal receiver  

The  following   should  be   noticed  to   ensure  an  economical  
operation.  

OPERATION  TIMER 

DEF./FAN  ALARM 

Operation lamp   Timer indicator  

Alarm indicator 

Adjust the air   flow louver properly and avoid direct    air flow to  
room inhabitants.  

PRE-DEF indicator(cooling and heating type)   
or fan only indicator(cooling only type)  

Adjust   the   room   temperature   properly   for   a   comfortable  
environment. Avoid excessive heating or cooling.  

(figure 1)    

Display panel 

This function is used to operate the unit temporarily in case you  
misplace  the  remote  controller  or  its  batteries  are  exhausted.  
Two  modes   including  AUTO   and  FORCED   COOL  can  be  
selected through the TEMPORARY BUTTON on the air-in grill  
control box of the indoor unit. Once you push this button, the air  
conditioner  will  run  in  such   order:  AUTO,  FORCED  COOL,   
OFF, and back to AUTO.  

Prevent   direct  sunlight   during   cooling   operation   by  using  
curtains or blinds.  

Ventilate  often.   Extended  use  requires   special  attention   to  
ventilation.  

Keep  doors  and  windows  closed.  If  the  doors  and  windows  
remain open, air will flow out of your room causing a decrease  
in the cooling or heating effect.  

AUTO 
The  OPERATION  lamp  is  lit,  and  the  air  conditioner  will  run  
under AUTO mode. The remote controller operation is enabled  
to operate according to the received signal.  

Never place objects near the air inlet or the air outlet of the unit.  
It may cause deterioration in the effect or stop the operation.  

FORCED COOL  

Set the timer .  

The  OPERATION  lamp flashes, the air  conditioner will   turn  to  
AUTO after it is enforced to cool with a wind speed of HIGH for  
30 minutes. The remote controller operation is disabled.  
   
OFF  
The  OPERATION  lamp  goes  off.  The  air  conditioner  is  OFF  
while the remote controller operation is enabled. 

If you don't plan to use the unit for a long time, please take the  
batteries  from  the  remote  controller.  When  the  power  is  on,  
some energy will be consumed,even if the air conditioner isn't in  
operation. So please disconnect the power to save energy.   

3  

NOTE  

This   manual   does   not   include    Remote   Controller  
Operations,    see   the<<Remote    Controller    Owner's  
manual>> packed with the unit for details.   

owner's manual 

Summary of Contents for KFC-CIS-2T-1200D













Reviews: