EN
47
bike, press the button again for 2 seconds. The
display and control unit switch off.
NOTE:
If the bike is not used for 10 minutes the
display unit switches off automatically.
Speedometer
The speedometer can show the instant
speed, average speed and maximum speed.
The instant speed is shown automatically by
default. To switch over, press the buttons
and
for 2 seconds. The following is then
shown: instant speed (km/h) → average speed
(km/h) → maximum speed (km/h).
1. Instant speed
2. Average speed
3. Maximum speed
FIG. 6
Odometer
When the display unit is started the odometer
is shown as a standard trip distance. To switch
over (trip meter/total distance) press the button
. The display then shows: trip distance (km)
→ total distance (km). To reset the trip meter,
press the buttons
and
.
1. Trip distance (TRIP)
2. Total distance (ODO)
FIG. 7
Backlight
Press the button
for 2 seconds to switch on
the backlight. The headlight goes on at the
same time. To switch off the light, press the
button
for 2 seconds again.
FIG. 8
Selection of assistance level
Press the button
or
to adjust the
assistance power of the motor. There are five
assistance levels, 1 to 5. 1 is the lowest and 5 is
full power. The standard setting is assistance
level 1. Three examples of how the assistance
levels are shown on the display:
1. Assistance level 1
2. Assistance level 2
3. Assistance level 5
FIG. 9
Battery indicator
The battery charge is shown on the display
in 5 levels. FULL is shown at the top of the
battery charge indicator when the battery is
fully charged. When the battery is discharged
(low battery voltage) the letter E is shown at
the bottom of the battery indicator and the
indicator flashes. The battery must then be
charged.
1. Fully charged battery
2. Partially discharged battery
3. Fully discharged battery (the indicator
flashes)
FIG. 10
Error codes
Error codes are shown automatically if there is
a fault in the control electronics. Check the part
of the bike to which the error code refers, or
hand in the display unit for repair.
Error code 21: circuit fault
Check that all connections are correct,
undamaged and not short-circuited.
Summary of Contents for 005023
