9
12.As shown in the picture, install the front
guard at the front of the frame, and use tool
⑨
(12mm socket)
⑭
(torque wrench) to tighten W
(M8 * 12 bolts*4) and J
（
Φ 8 * 13 * 2 spring
washer*4) fixing screws (torque requirements
25-30 N·m).
13. As shown in the picture, put V (fixing clamp Φ
51-70)into the lower suction pipe orifice of the
engine, insert M (upper suction pipe) into suitable
position of pipe orifice , and tighten it with tool
⑧
(cross screwdriver).
14. As shown in the picture, use tool
①
(8 #
wrench)
②
(10 # wrench) to tighten the fixing
point at the lower end of the upper suction pipe
with screws Q (M6 * 16 bolts*2 and
self-locking nuts M6*2) and the frame beam
(pay attention to the installation strength and
do not crack the plastic parts).
