Camera Link Range Extender over Fiber User Manual
13
5.1.4
Installing the SFP+ Module
In order to install the SFP+ module, follow these steps:
1.
The CL Extender unit supports the following SFP+ modules:
KY-SFP-10G31-10 – Allows of up to 10Km connection over single mode fiber cable
(duplex)
KY-SFP-10G85-3M – Allows of up to 300m connection over multi-mode fiber cable
KY-SFP-BD-10G-10 – Allows of up to 10Km connection over single mode fiber cable
(simplex)
Note: We are offering variety of customizations, to fit your application exact needs.
Please, Contact KAYA Instruments’ representative for any additional module options,
distance ranges, etc.
2.
The SFP+ module has a bale clasp that used to remove or install the SFP+ module.
3.
Close the bale clasp before inserting the SFP+ module.
4.
Line up the module with the port and slide it into the port as shown in Figure 4.
5.
Make sure that the male connectors on the module will align with the female connectors
inside the cage.
6.
Verify that the modules are completely seated and secured in their assigned receptacles
on the line card by firmly pushing on each module. In case the module is not completely
seated and secured in the receptacle, you will hear a click as the triangular pin on the
bottom of the module snaps into the hole in the receptacle.
7.
Follow the exact steps to insert additional module into the second Camera Link Extender
unit.
Figure 4 : Installing an SFP+ Module into a port
Installation and Configuration
