Camera Link Range Extender over Fiber User Manual
10
4.3
LEDs description
Each unit has several status LEDs, as seen in Figure 2.
SFP+
LED
System
status LED
CL
LED
CL
LED
Figure 2 : KY-EXT-CL
LEDs description
The System status LED, located on the Camera link side, always slow pulses in green while the
system is ON. While in firmware update mode, this LED slow pulses orange. In any case of system
failure, the LED will constantly light orange.
The Camera Link LED’s behavior is described in Table 1:
LED state
Condition
Slow pulse red
No valid Camera Link link detected
Solid red
PoCL failure (Overcurrent/Under voltage/Overvoltage)
Solid green
Camera link is active
Table 1 : Camera Link status LEDs behavior
The SFP+ LED behavior is described in Table 2:
LED state
Condition
Fast flash red
SFP+ is unplugged
Solid red
SFP+ is not compatible
Slow pulse red
No signal detected on optic fiber
Fast flash green
Link is being established
Solid green
Link is active
Table 2 : SFP+ status LEDs behavior
System Description
