Page no. 10 | System Description
SFP+
LED
System
status LED
CL
LED
CL
LED
Figure 2 : KY-EXT-CL LEDs description
The System status LED, located on the Camera link side, always slow pulses in green while the system is ON.
While in firmware update mode, this LED slow pulses orange. In any case of system failure, the LED will
constantly light orange.
The Camera Link LED’s behavior is described in Table 2:
LED state
Condition
Slow pulse red
No valid Camera Link link detected
Solid red
PoCL failure (Overcurrent/Under voltage/Overvoltage)
Solid green
Camera link is active
Table 2 : Camera Link status LEDs behavior
The SFP+ LED behavior is described in Table 3:
LED state
Condition
Fast flash red OR fast flash yellow
SFP+ is unplugged
Solid red
[1]
SFP+ is not compatible
Slow pulse red OR slow pulse yellow
No signal detected on optic fiber
Fast flash green
Link is being established
Solid green
Link is active
Table 3 : SFP+ status LEDs behavior
1.
Only exists in:
-
Host: version 1.15 and older
-
Device: versions 1.44 and older.
