7
Note:
The PRNU and DSNU depends on exposure, gain, temperature and number of active fiber links. In
case the above conditions might change during camera operation, it is advised to pre calibrate the
system on several conditions and save them as different user sets. Load the user set if the conditions
have been changed. User set control is described in the next section.
3.3
User Set Control category
1
2
3
4
5
6
7
Figure 7 : Saving camera parameter configuration
Eight user sets are available for saving different camera parameter configurations. In addition, a
“Default” UserSet is available so it will be possible to revert back to default factory settings.
1.
Selection between the different available user configuration
Default – Factory settings
UserSetX - Available user sets in non-volatile memory
2.
Load the configuration of the selected user set
3.
Save the configuration to the selected user set
4.
Selection of the power up configuration
Non-volatile memory is available for user usage. Data save to this memory space will not be erase
upon camera power-down.
5.
Execute an erase of the entire user memory on the camera
6.
Selection of the memory page for saving
7.
Execute a save to the selected memory page
Using the DSNU and PRNU corrections
