47
ED
IT
M
en
u
EDIT Menu parameters
(INT mode)
3. Trigger Mode
n
ormal
, f
ast
This parameter selects the trigger point for the keyboard.
A fast/higher trigger point may be useful when playing sounds that are
traditionally played on non-weighted keyboards such as organ or synth.
Trigger Mode Description
Normal
The keyboard trigger point is normal.
Fast
The keyboard trigger point is earlier than Normal.
* When either Fast mode is selected, all touch response functionality will be
disabled, and an asterisk will be shown beside the relevant Touch Curve,
Dynamics, Min.Touch, and VeloSW parameters.
* This parameter will only by visible for the MAIN zone, but when either Fast
mode is selected will affect all zones.
4. Minimum Touch
value
: 1 ~ 20
This parameter adjusts the minimum key velocity required to
produce a sound.
5. Octave Shift
value
: –3 ~ +3
octaves
This parameter adjusts the amount of octave transposition for
the selected sound.
* This parameter is not stored to SOUND but to SETUP only.
6. Zone Transpose
value
: –12 ~ +12
This parameter adjusts the amount of transposition for the
selected zone.
* This parameter is not stored to SOUND but to SETUP only.
7. Key Scaling Damping
o
n
, o
ff
This parameter determines whether or not damping (velocity
reduction) should be applied to a sound over a specific range.
This parameter may be useful when layering a piano sound with a strings
sound, in order to reduce the level of the strings in the higher key range.
8. Key Scaling Key
range
: a0 ~ c8
This parameter defines the point on the keyboard from which
Key Scaling Damping should be applied, up to the highest key.
9. Key Range Zone Lo
range
: a0 ~ c8
This parameter defines the bottom key of the selected zone.
* For more information about adjusting the zone key range, please refer to
* This parameter is not stored to SOUND but to SETUP only.
10. Key Range Zone Hi
range
: a0 ~ c8
This parameter defines the top key of the selected zone.
* For more information about adjusting the zone key range, please refer to
* This parameter is not stored to SOUND but to SETUP only.