Instructions for use MASTERtorque Mini LUX M8700 L - 3.001.0000MASTERtorque Mini LUX M8700 LK -
3.001.3400MASTERtorque Mini LUX M8700 LS - 3.001.0600
5 Operation | 5.4 Inserting the milling tools or diamond grinders
14 / 30
5.4 Inserting the milling tools or diamond grinders
Note
Only use carbide cutters or diamond grinders that comply with EN ISO
1797-1 type 3, are made of steel or hard metal and meet the following cri-
teria:
- Shaft diameter: 1.59 to 1.60 mm
- Overall length: max. 21 mm
- Shaft clamping length: at least 9 mm
- Blade diameter: max. 2 mm
WARNING
Use of unauthorised dental burs or diamond grinders.
Injury to the patient or damage to the medical device.
▶
Comply with the instructions for use and use the dental bur or diamond
grinder properly.
▶
Only use dental burs or diamond grinders that do not deviate from the spe-
cified data.
CAUTION
Use of dental burs or diamond grinders with worn or damaged shafts.
Risk of injury, tool may fall out during treatment.
▶
Never use dental burs or diamond grinders with damaged or worn shafts.
CAUTION
Danger of injury from cutters or grinders.
Infections or cuts.
▶
Wear gloves or finger stalls.
CAUTION
Hazard from defective chuck system.
The cutter or grinder could fall out and cause injury.
▶
Pull on the dental burr or rips abrasives to check if the clamping system is
functioning properly and that the tool is firmly clamped. Wear gloves or a
thimble to check, insert, or remove the bits to prevent injury and infection.
NOTICE
Tool shaft slips inside the chuck due to excessive speed of the tool or
abrupt engagement of the tool.
Material damage to tool shaft and chuck system, reduction of the service life of
tool and chuck system.
▶
Do not operate the tool at a higher speed than recommended by the manu-
facturer.
NOTICE
Use of dental burs or diamond grinders with worn or damaged shafts.
Material damage to the chuck system, tool is difficult or impossible to remove
from the chuck system.
▶
Do not use dental burs or diamond grinders with damaged or worn shafts.
▶
Forcefully press the push button with your thumb and simultaneously insert
the cutter or grinder all the way.
