4
5. CHARGER/BATTERY PACK/CIRCUIT BOARD PRECAUTIONS
1. Always connect the battery in correct polarity. See as below.
2. Never leave the battery and charger unattended. Keep away
from fire to avoid explosion and injury.
3. To prevent the LiPo battery pack from being overcharged,
which could lead to damage or explosion, the charger uses a
voltage limit protection device.
4. The battery uses a low voltage and current over-discharge
protection device. When the battery is over-discharged, a re-
-charge is required to activate the battery again. When the car
is not being used, turn the switch to OFF position and remove
the battery.
5. The electronic speed controller has thermal protection functi-
on. When the circuit board is overheated, the car will be disab-
led (not moving forward/backward) for 3-6 seconds before the
normal operation is resumed.
6. If you are not riding your car, please take the battery out of the
vehicle.
6. TRANSIMITTER FUNCTION
1. Forward
2. Brake
3. Left
4. Right
5. Backward
NEUTRAL
A. ON/OFF Switch
B. Steering Trim
C. Steering Dual Rate Adjustment
D. Steering Reverse Switch
E. Speed Mode (Full Speed and Half Speed Mode)
F. LED Indicator
7. CONTROLLING THE VEHICLE
(1) TURN ON YOUR VEHICLE
Press and hold the ON/OFF button for 3 seconds to turn your car on.
(2) Install the battery in the indicated direction, secure the battery in place with the two locks. (Rotate the locks in the indicated direction until it clicks.)