5
EN • Screen installation and operation manual
IMPORTANT SAFETY INSTRUCTIONS
1.
Please read through the user manual carefully before using the product,
and follow all of the procedures in the manual to safety use of the
product.
2.
Keep these operating instructions in a safe place and pass them on to
any future user.
3.
Take special note of all warnings listed in these instructions and on the
unit.
4.
Follow Instructions - All operating and use instructions should be
followed.
5.
Before. Use a soft, damp cloth for cleaning. Do not use active cleaning agents.
Protect the screen against the ingress of water or other liquid inside. After
cleaning, the screen should be carefully wiped to remove any residual moisture.
Do not use the product near water, for example, near a bathtub, washbowl,
kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc.
6.
I do not place the projector screen in direct sunlight or near heat sources such as
radiators, fires or stoves.
7.
Children: Always use this device (screen) out of reach of children.
INSTALACYNSTALLATION AND OPERATIONAL RULES
1.
The screen should be installed in rooms with room temperature (15 -
25°
C), away from moisture and sunlight.
2.
The screen should not be attached to heat sources. Incorrect adjustment
of the
screen
may permanently damage
the projection surface.
3.
The properly mounted screen should be perfectly level at every scale.
THE DISPOSAL OF UNUSED OR WASTE PRODUCT
Due to the design of the projection screen, it must be disposed of in accordance with the
environmental standards
. After product operation finish it should be removed
in separate, specially specified point:
- a municipal waste disposal point with appropriate containers for this type of equipment,
- waste containers at the sale point
These products will be recycled, which will prevent the release of substances contained in them into the environment, and the components will be reused.
OGENERAL PRODUCT-RELATED INFORMATION
1.
DIMENSIONAL TOLERANCE:
a.
projection area: ± 2%,
b.
components ± 3mm
