w w w . k a u
-3-
b e r . e u
IMPORTANT!!!
INSTALLATION AND OPERATION NOTES
1.
The cassette and the bottom bar of the screen are protected against damage by polyurethane foam.
Remove the foams protecting the bottom bar after mounting the screen.
2.
The screen should be installed in a location away from moisture and strong sunlight.
3.
A properly mounted screen must be absolutely levelled.
4.
Use a soft, moistened cloth for cleaning. Do not use active cleaners. Protect the screen from ingress of
water or other liquid inside. After cleaning, the screen should be carefully wiped to remove any
residual moisture.
5.
DIMENSIONAL TOLERANCE: Projection surface: ± 20mm; components ± 3mm
6. The screen / elevator cannot have connected more than one remote control at once.
7.
One remote control (for ex. RC01 / RC02 / Trigger 12V / Trigger230V / IR Receiver / RS Receiver,
etc.) cannot be connected at once to more than one screen, elevator, roller-blind, etc. Such connection
can only be made by using the SG-2 group controller.
Package contents:
Qty.
Projection screen
1 pcs
Mounting bracket
2 pcs
Screws for the bracket
8 pcs
Expansion dowel Ø10
4 pcs
M6 washer
4 pcs
Wrench for adjusting the end positions of the screen
1 pcs
Wall key switch (available for screen without a built-in radio control)
1 pcs
Blue Label is a series of electric projection screens in anodized aluminum housings. A timeless
design and a wide selection of projection surfaces make it the most-chosen screen for home theater and
conference rooms. In the Tensioned version it is additionally equipped with a special system of tensioners
to get an even more tense projection surface.
Switch
Switch
Screen / elevator
engine
Screen / elevator
engine
Screen / elevator
engine
Controls
