Kathrein UFS 910, Operating Manual

Page: 29 / 88

29
Execute Channel search
Use the buttons to select (yes or no) whether you wish to start a channel search. It is not essential
to start a channel search; instead you can use the factory pre-programmed channels. However the
channels do change from time to time (e.g. their frequencies change), which the receiver does not
automatically detect, and can then be found only by performing a channel search.
If you selected “No”, you can press the
!
(green) button to skip directly to the next item of the fi rst
installation.
If you selected “yes”, you can press the button to progress to the next selection item.
Channel Search Mode
Use the buttons to select whether you wish to search for “free & scrambled”, “free channels only” or
“scrambled only” channels.
To view scrambled channels you need the appropriate CA (Conditional Access) module and a
valid smart card together with a valid subscription to a pay TV provider.
Press the button to move to the next selection item.
Network Search
If you set the network search to “Off”, only the factory stored transponders of the satellites you previously
selected will be searched for new and as yet unlisted channels.
If you set the network search to “On”, the transponder network enables additional transponders that have
not yet been stored to be located. They are then stored and searched for new channels in the
same way as the existing transponders.
Press the
!
(green) button to start the channel search, or if you set channel search to “Off” you are
guided straight to the next item in the fi rst installation process.
When the search has been completed, you will see the following message (example):
FIRST INSTALLATION: Channel search