Kathrein UFD 520, Operating Manual

Page: 22 / 60

Timer settings
Timer settings
You can use the timer for recording a programme with a video recorder on time.
Seven timers are available which you can set to different programmes as well as
start and end times.
To access the timer setting, press
M
to enter the main programme menu,
uo
to go to system parameters,
followed by
O
and
uo
to local
time / timer and
O
. The screen shown
in the margin appears.
Press the
ou
buttons to move the
cursor to the desired timer and confirm it
by pressing
O
. Press
L
to exit the
timer again.
Incorrect time settings will be rejected.
You can select and set
·
the programme type, TV or radio,
·
the programme location with name (numerical via the remote control),
·
the start time (date, month, year, hour, minute)
·
the stop time and
· the timer status (inactive/once/daily/weekly)
for seven timers. You must enter leading zeros for the time settings.
You can also carry out the pre-programming via the EPG (Electronic Program
Guide). Refer to section „Programme overview – Full EPG."
Use the
-
or
+
and the number buttons to make the required setting.
The current time that you must re-enter appears under the start time. If no other
setting is entered, the end time will be set automatically to the same date and one
hour after the start time.
Finally confirm the settings by pressing
M
or
L
3 times.
VPS-Signal
Make certain, that no VPS signal is included in the digital television signal.
Therefore, you will need to programme your video recorder corresponding to the
timer settings.
22