Satellites Menu
24
Satellites Menu
The ASTRA satellite is set ex works. Further seven satellites, e.g.
EUTELSAT/HOTBIRD, are pre-programmed. On extension of your re-
ception system you can make the required settings for the pre-
programmed seven satellites in the “Satellite Selection” menu.
You activate the required satellite number, e.g. with the number button
[1-8] and select the entry menu with the [OK] button.
1. Enter or change name
Activate the {NAME} input field with the button [1] and with [OK].
You can select letters (large and small) or numbers with the [
▼
] or [
▲
]
buttons.
You can shift the entry position to the right or left with the [
►
] or [
◄
]
buttons.
After the desired name is entered, the input field is deactivated again
with [OK].
2. Enter LO1
3. Enter LO2
LO1 and LO2 are preset to 9.750 MHz and 10.600 MHz ex works.
Should the LNB-LO frequencies deviate from the preset values, then
enter the corresponding values here. Activate with [OK] and enter the
LO frequencies with the number buttons [0]-[9], conclude with [OK].
Please make sure that an LNB with digital capability is installed in
your reception system.
4. Enter orbit position
Note:
The “Orbit-Position” parameter, possible values 1-4, must be stated
for the control via DiSEqC
TM
.
DiSEqC
TM
1.0 4 sat. positions
1-4
DiSEqC
TM
1.1 16 x 4 sat. positions (uncommitted switches) 1-16/Off
Since corresponding switches with which the matrices are controlled
are required for controlling DiSEqC
TM
1.1
,
the cabling is very compli-
cated and should be installed only by an experienced installation en-
gineer!
Enable
{ON}
The selected satellite is enabled for your reception system.
{OFF} The selected satellite is locked.
Summary of Contents for UFD 516
