6 / 8
17. Mount the turning handle and the crank handle. Do not
twist the cable in the joint tube. To avoid twisting:
a. Put the cable through the turning handle.
b. Push the turning handle on the tube until it sits.
c. Secure the turning handle with an M5x8 screw.
d. Attach the crank handle.
e. Secure the crank handle with an M4x12 screw.
18. Put an insulating sleeve
between the moun-
ting bracket and the
ceiling (not included in
the scope of delivery,
recommended for winter
caravanning).
19. If it is necessary to
retighten the circular
spring, shorten it by
nipping off ca. 2 mm.
Tip
Please note that during the first use of the mast it is slightly difficult to move it. After a couple of adjustments
it is easier to move the mast.
Cable connection
Attach the F-Type connector
Only use the enclosed F-type connectors. Do not use any tools to attach the F-type connectors, tighten them hand-
tight.
NOTICE
Risk of short circuit!
Material damage due to contact between the wires of the braided shield and the inner conductor.
►
When attaching the F-type connectors, make sure that there is no contact between the wires of the braided
shield and the inner conductor.
1. Remove 10 mm from the outer plastic jacket
①
. Cut into it carefully not to
damage the braided schield
②
.
2. Put the braided shield
②
back.
3. Remove 7 mm dielectric
and aluminium foil ③
from the inner conductor
④
.
4. Screw the F-type connector
⑤ onto the end of the cable until it sits tightly.
② ③ ④
①
⑤
Connect the cable to the antenna
Connect the antenna cables to the antenna as described in the user manual for the antenna.
Connect the cable to the receiver/TV
Connect the antenna cables to the receiver or TV as described in the user manual for the receiver or TV.
Summary of Contents for HDM 140
Page 20: ......
