2 / 8
Transport and Storage
►
Use the original packaging for trans-
porting the device; store it in a dry
place.
►
Make sure there is no water condensa-
tion build-up.
CAUTION!
Risk of damage to the device if operated in inappropriate ambient conditions!
►
The equipment may only be installed in dry indoor areas. Do not install
the equipment on or against easily combustible material
►
The equipment must be provided with an equipotential bonding wire (Cu,
at least 4 mm
2
)
►
The safety regulations set out in the current EN 60728-11 and EN 62368-1
standards must be complied with
►
Fasteners: wood screws, max. Ø 4.5 mm
►
Connectors: RF connectors 75 Ω (F series) compliant with EN 61169-24
►
Unused subscriber ports should be closed off using 75 Ω resistors (e.g.
EMK 03)
Risk of damage to property!
If the diameter of the inner cable conductor exceeds 1.2 mm or if there is a
burr, the device sockets may be damaged beyond repair.
Max. 2 mm
excess length
Clamping torque
max. 3.4 Nm
(danger of over-
winding)
Diameter
0.6 - 1.2 mm free of burrs
Mounting Instructions
Intended use
The equipment described is designed solely for the installation of satellite receiver
systems.
Any other use or non-observance of these instructions will result in the loss of the
warranty and guarantee.
Scope of Delivery
●
EXD 154
●
Instructions for use for EXD 154
