Kathrein BAS 60, User Manual

Page: 18 / 48

6 / 12
Connecting the cable to the antenna (Fig. 7)
1. Loosen the two knurled screws and remove the LNB cover.
2. Connect the F-type plug as shown.
3. Connect the cable to the LNB.
4. Now press the cable (outer diameter 6.8 mm) into the cable
support. If you use the thinner cable (e.g. for Sat jointed
masts HDM xxx with integrated cables), first put the supplied
sleeve on the cable in order to compensate the diameter.
5. Re-fit the LNB cover.
Connecting the cable
Refer to the operating manual of your satellite receiver for this.
Setting up the receiver
Connecting the cable to the receiver
1. Mount a F-type connector to the end of the cable pointing to
the receiver.
2. Connect the BAS 60 to the receiver. To do so, connect the
cable to the Sat input on the rear panel of the receiver.
In the example on the right (UFS 940), insert on the input “IF
INPUT”.
Refer to the operating manual of your satellite receiver in
this respect.
Abb. 8
Abb. 7