9
Dual key functions:
The keypad features pre-defined dual key commands that allow you to trigger a fire,
panic, or medical alarm without entering a PIN code. To activate the dual key
functions, please proceed as follows:
Enter the installation mode of the keypad (default 0000 + *). The power LED lights up
orange. To activate the dual key function, you need to enter the following commands
for the corresponding functions:
* + 2 = Activate dual key 1 + 3 panic alarm
* + 3 = Activate dual key 4 + 6 fire alarm
* + 4 = Activate dual key 7 + 9 medical alarm
* + 5 = Deactivate all dual key functions
Notes:
•
For using the dual key function it is necessary to press the commands at
least for three seconds.
•
To execute the dual commands press always only two keys on the keypad
and no other keys!
Additional functions of the installation mode:
* + 7 = Adding the keypad to the alarm panel / range test
* + 6 = Changing the installation PIN
•
Enter the current installation PIN (default 0000).
•
Press the status button
. A long signal is emitted.
•
Enter your new installation PIN code (4-digits).
•
Press the pound button (#). The new installation PIN code is now saved.
* + 8 = Enable switching to arm / home mode without entering a PIN code
* + 9 = Disable switching to arm / home mode without entering a PIN code
To exit the installation mode, press the disarm button two times.
Reset / factory default:
If you have forgotten your installation PIN code, you can restore the factory default of
the keypad in the following way:
1.
Open the keypad. Be aware that the tamper protection will be triggered!
2.
Remove the batteries.
3.
Press and hold the button “3” while you are inserting the batteries again.
4.
Release the button “3”.
5.
After the reset, the installation PIN code will again be 0000.
Notes:
•
In the menu “Settings”
“Panel”
“Area Settings”
“Arming with failure”
you can allow that the alarm panel will always switch the mode irrespective
of errors.
•
If an error is displayed by a flashing error LED, it can be ignored by entering
the PIN code and the mode command again within ten seconds.
•
Current errors are displayed and can be ignored in the menu “Home”
“Status”.
•
The keypad transmits its status "only" during input. Although it can be
transmitted that the batteries are getting weak but not that they are empty.
