6 / 36
V = 0°
V = –20°
V = +20°
0°
1
2
Aligning the Antenna
The antenna must be exactly aligned towards the satellite in
respect of both the direction (azimuth) and also the inclination
(elevation). For multi-feed applications the antenna should be
aligned towards the satellite which is transmitting the weakest
signal level.
a. Adjusting the inclination (elevation)
–
Use an allen wrench SW5 (
①
) supplied with the parabolic
antenna to slacken the two screws on each side of the
inclination scale
(elevation) on the
left and right
of the
support.
Do not slacken the upper nuts (
②
) on the bra-
cket – these are factory-set to a fi xed tighte-
ning torque.
–
Then adjust the
inclination
(elevation) – the exact eleva-
tion angle for your location can be found in the manual
for the feed system (LNB).
–
When doing this, retighten fi rst just one of the bolts on
the inclination scale fi nger-tight (
①
).
b. Setting the direction (azimuth)
If you yourself are unable whilst performing the adjustments
to read the results of the alignment work on an
antenna
meter
or
screen
connected to the satellite receiver, you may
need an assistant for the following steps. The precise align-
ment of the antenna can be achieved only if a digital antenna
meter is used. Ask your dealer about this.
–
Set the satellite receiver to a known channel so that you
can check that you have really “locked on” to the desired
satellite.
–
Now slightly loosen the wing nuts on the mast clamp (
③
).
–
Twist the antenna so that it faces roughly south. Then
slowly twist the antenna about its central axis to left and
right until the best reception is obtained for the selected
channel.
–
Then tighten the
wing nuts
initially just enough to pre-
vent the antenna turning.
Scale V angle
Direction of rotation for
polarisation angle (PW)
●
Multiple feed systems (multi-feed)
To optimise the multi-feed reception, the tiltable support
“H” should be tilted to the angle “V” according to the table
attached to this document.
The polarisation angle on the respective feed system must be
set according to the following formula.
PW
NEW
= PW
TAB
- V
PW
NEW
= polarisation angle to be set
PW
TAB
= polarisation angle of the selected satellite according
to the table in the LNB user instructions
V = setting angle of the support according to the selected
satellite combination of the attached table
With the settings and the calculation, pay attention to
preceding signs!
In order to be able to tilt the support you must fi rst use the
hexagon key to slacken the bolt shown arrowed in the illus-
tration on the right.
