TECHNICAL INFORMATION
Model:
TF 480
Watts:
2000W
Volts:
230-240 V 50 Hz
Lamp:
2.5W
Fan Heater:
1000 OR 2000 W
Important
The wiring in this mains lead is coloured in accordance with the
following code:
European Fires (CE approved)
EARTH:
GREEN and YELLOW
NEUTRAL:
BLUE
LIVE:
BROWN
Replacement fuse must conform to British Standards and be rated at 13A.
OPERATING INSTRUCTIONS
The appliance control switches are located underneath the canopy on the left hand side of the fire.
The switches will look like the diagram below. It is important to be aware that switches must be
turned on in the correct sequence. ‘A’ must be on prior to switching on ‘B’ to operate at 1Kw. ‘A & B’
must be on prior to switching on ‘C’ to operate at 2Kw. Switching off ‘A’ will disable both ‘B & C’
Heating Appliance Settings
SWITCHES
POS.
SETTING
A
OFF
OFF
A
ON
FLAME EFFECT ONLY
A + B
ON
FLAME EFFECT LOW HEAT (1Kw)
A + B + C
ON
FLAME EFFECT AND HIGH HEAT (2Kw)
BULB MAINTAINENCE
ILLUMINATED PEBBLE BED BULB REPLACEMENT
Due to the fact that the illumination is provided by LED’s there should never be a requirement to
change the bulbs for the lifetime of the fire. Should you have any problems contact our customer
service department on 01325 379060
Thermostat Operation
Set the thermostat wheel (pictured above right) to its highest setting.
When the room gets to a comfortable temperature slowly turn the
thermostat wheel down until the heater fan switches itself off. The
thermostat is now set, to re-adjust repeat the same process again.
