IMPORTANT INSTALLATION INSTRUCTIONS
IMPORTANT INFORMATION ABOUT YOUR ELECTRIC FIRE
Please read these instructions carefully before operating this appliance.
•
Do not use the appliance near a bath, shower or swimming pool. Make sure it can not fall into water.
Never touch the appliance with wet hands.
•
This product must be connected to earth.
•
If you run the appliance on heat setting 2Kw with another piece of equipment running on the same
circuit the appliance fuse may blow or your circuit breaker may switch off the supply. Reconnect one
of the appliances to another circuit.
•
A non-rewireable plug with a 13A fuse is supplied. Should the fuse or plug need replacing and you are
competent to do so, it must be replaced with a 13A fuse or plug being 13amp BS1363A approved.
•
Do not use the appliance in rooms that have explosive gas in them (for example petrol), or if you are
using solvents, glue, aerosol sprays or inflammable paints as they may catch fire.
•
Make sure that children do not play with the appliance or stick objects into it.
•
Do not cover or hang anything over the front or top of the appliance as overheating may result.
•
Ensure the outlet grille is not obstructed in any way as this could cause the appliance to overheat and
may also cause damage to the item obstructing the grille.
•
The appliance is fitted with an automatic thermal cut out to reduce the risk of damage in the event of
abnormal operation e.g. when covered. If the heater stops operating while the flame effect continues
normally, this indicates that the cut out is in operation. It will automatically re-set when cool enough,
but first remove any obstruction to the fan heater or blades. Make sure the power lead is disconnected
at the mains before you do this. The thermal cut out WILL NOT RESET unless the obstruction is
removed and the appliance cools. If the heater will not operate after 10 minutes disconnect and seek
expert advice.
•
Ensure that the plug socket connection or any fixed switched fused spur connection for the appliance
is accessible. It MUST be readily accessible for easy electrical isolation in the event of servicing and
replacing bulbs etc.
•
If the supply cord on the appliance is damaged the appliance MUST NOT be used. A competent person
must replace the power cord if required. The power cord used MUST be capable of handling 2.5Kw of
power at 240v and MUST contain an earth wire.
•
A suitably qualified electrician may connect the appliance to an accessible fixed fused spur.
•
Bulbs with a rating in excess of 11w must not be used on this appliance.
•
The fixing strap provided must be secured to the back of the suite with the washer and screw supplied,
it then must be fixed to the wall using suitable fixings for your wall type.
OPERATING THE APPLIANCE
•
Plug the appliance into a suitable 13A mains outlet socket and switch on.
•
Switch on the right hand switch under the right hand side of the canopy (marked 0 and I) and the
flame effect will start.
•
When heating is required make sure that the thermostat wheel is on the high setting and next press
either heat 1 (marked with red I) or heat 1 and heat 2 (marked with red II) switches under the canopy
for either 1Kw or 2Kw respectively. The heat 1 switch will only provide 1Kw of heat whilst both the heat
switched together will provide 2Kw of heat.
•
If no heating is required make sure the heat 1 and heat 2 switches are in the off position.
