8
Cod. 2050-0001 Rev 1.1
3
INSTALLATION
WARNING
Equipment installation must be performed by qualified technical personnel; detailed
instructions for installation are in the “Technical Manual ".
User should not perform equipment installation.
The room in which the appliance is installed must have a floor drain to prevent
damage to persons or property in case of flooding.
Install the device in a cool, dry, well-ventilated area. Interception and by-pass valves,
display, power plug and pre-filter must be visible and accessible to the user.
Use washing machine pipes conforming to EN61770 and that have a diameter not lower
than DN10. Do not reuse old or frayed pipes.
To install the device in accordance with EN 1717 and WRAS, order the accessories
separately; install upstream of the equipment a certified anti-pollution device <CA> and
an air interruption in drain.
The electrical power socket must be in compliance with the specifications listed in
the CE plate, with an efficient ground and protected by 0.03 mA differential switch. If
the power cord is damaged, it must be replaced by the manufacturer, dealer or a
similarly qualified person so as to avoid any safety risks.
The machine’s power supply must be protected against overcurrent (short circuits
and overloads) by fuses or suitable thermal magnetic circuit breakers. These must
be assembled on a single-core disconnecting system, which has a contact gap of at
least 3 mm.
Do not subject the device to excessive temperature changes that may create
condensation inside, which may damage the electrical parts.
The equipment can be installed in horizontal or vertical position, with the cover
oriented upwards, every other position is prohibited.
Do not obstruct the rear ventilation grills.
Be careful not to bend or clog the drain pipe.
We recommend installing a pressure gauge on the pump delivery line to check the
operating pressure
INSTALLATION CONNECTIONS
1.
Water Inlet ¾” G M
2.
Filter first washing”
3.
Bypass valve and mix
4.
Power supply socket
5.
Quick release drain ¼
6.
Permeate outlet ¾” G M
