33 / 73
•
Then lift the holder with the arm and
install the top retaining ring to the
hook.
•
Push the spare wheel lowering arm
into the slot, firstly insert the hook
then the top retaining ring and fix it
to holder.
3.10. Mudguards
Your vehicle is equipped with mudguards
and/or mudflaps which are suitable for
regulations. The water will be splashed
from the ground etc. will be minimized
thanks
to
these
mudguards
and
mudflaps.
Some vehicles may have foldable mud-
flaps in order to prevent mudflaps from
damage. This type of mudflap has to be
folded
(1)
during
the
huckepack
operations.
When you are driving, the fol-
dable
mud-flaps
must
be
opened.
3.11. Wheel Chock
There are two units wheel chocks and
holders in the vehicle.
The vehicle must be secured
with wheel chocks when par-
ked on a slope area, during
the
loading
and unloading
operations or when parked
without a tractor.
Only place wheel chocks on
wheels on fixed axles, never
on idle/steer axles.
When the wheel chocks is fi-
xed inside the holder, be sure
that the pins will be mounted
properly.
After driving operations, place
the wheel chocks properly.
3.11.1. Pin Type Wheel Chock Holder
Removing the wheel chock from hold-
ers:
Pull out the cotter pin (1) located at
the end of the wheel chock holder. Then
take the wheel chock from its slot by pull-
ing it sideways from the wheel chock
holder.
Wheel Chock
Placing the wheel chock from Its hold-
er:
Place the wheel chocks on the hold-
ers and mount the cotter pin (1) to pin.
