INSTALLATION INSTRUCTIONS
© 2019 Kason Industries, Inc. IS-8600EZ-200 Rev 6 03/19
kasonind.com | 1.800.935.2766 | PAGE 11
8600EZ Power Drive
Single Doors and Bi-Parting Doors
Part Number: 8600*
Job Site Installation
Step 1.
Begin job site installation by following instruction sheet “Installation Instructions - 8600EZ Single Door System” (IS-
8600EZ-14B).
! CAUTION!
Only qualified personnel should wire the motor unit and its remote accessories. Adhere to all
local electrical codes when installing this unit.
Mount control box as shown below in
Fig. 22
using appropriate fasteners and in the desired locations . Control boxes may be
mounted up high and out of reach if desired.
NOTE:
If control box requires mounting further than 9’ from motor, an intermediate
junction box is re-quired. It is
NOT
recommended to replace or alter the supplied wire inside the motor housing.
Mount photo eye at this time, if used. May be mounted on wall or floor as shown in
Fig. 22
.
STOP!
Assure chain is locked in the chain disconnect or connected to the door. See
Fig. 7.
WARNING!
Door must be engaged with
chain prior to power drive operation. Install all safety stickers shown in
Fig. 21
and
22
. Failure to engage chain could result in
damage to the power system.
Fig. 22
