1.
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the
ACTA. On the bottom of this equipment is a label that contains, among other information, a
product identifier in the format US:AAAEQ##TXXXX. If requested, this number must be
provided to the telephone company.
2.
A plug and jack used to connect this equipment to the premises wiring and telephone network
must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A
compliant telephone cord and modular plug is provided with this product. It is designed to be
connected to a compatible modular jack that is also compliant. See installation instructions for
details.
3.
telephone company will notify you in advance that temporary discontinuance of service may
be required. But if advance notice isn't practical, the telephone company will notify the
customer as soon as possible. Also, you will be advised of your right to file a complaint with
the FCC if you believe it is necessary.
4.
The telephone company may make changes in its facilities, equipment, operations or
procedures that could affect the operation of the equipment. If this happens the telephone
company will provide advance notice in order for you to make necessary modifications to
maintain uninterrupted service.
5.
warranty information, Service can be facilitated through our office at:
Kaito Electronics,Inc.
5185 Cliffwood Dr. Montclair CA 91763
Tel: 909 628 6088 ,Fax: 909 628 7999
If the equipment is causing harm to the telephone network, the telephone company may
request that you disconnect the equipment until the problem is resolved.
6.
Please follow instructions for repairing if any (e.g. battery replacement section); otherwise do
not alternate or repair any parts of device except specified. For repair procedures, follow the
instructions outlined under the limited warranty.
7.
Connection to party line service is subject to state tariffs. Contact the state public utility
commission, public service commission or corporation commission for information.
8.
If your home has specially wired alarm equipment connected to the telephone line, ensure the
installation of this [equipment ID
:DL
] does not disable your alarm equipment. If you have
questions about what will disable alarm equipment, consult your telephone company or a
qualified installer.
9.
If the telephone company requests information on what equipment is connected to their lines,
inform them of:
a)
The ringer equivalence number [01B]
b)
The USOC jack required [RJ11C]
Facility Interface Codes (“FIC”) [METALLIC ]
Service Order Codes (“SOC”) [9.0Y]
c)
10.
The REN is used to determine the number of devices that may be connected to a telephone
line. Excessive RENs on a telephone line may result in the devices not ringing in response to
an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To
If trouble is experienced with this equipment [US: U5IDL01BKW5212], for repair or
If this equipment [US:U5IDL01BKW5212] causes harm to the telephone network, the
The FCC Registration Number[US:U5IDL01BKW5212]
