4
Instructions for mounting lights on model:
8400VFX, 8400JF, 2.3VFX, 2.3JF, 3.1JF, 3.3JF,
5.1JF, 5.3JF, 5.1VFX, 5.3VFX, 7.3JF
2. Insert the 1/4” x 5” bolt into the light bracket and
extension as shown in Figure 9. Place this assembly
on the float bracket
Fig 9
3. Install the 1/4” Flat Washer, 1/4” Lock Washer and
1/4” Nut as shown in Figure 10. Tighten the nut until
snug using the 7/16” Wrench.
Fig 10
flat washer
lock washer
1/4” nut
4. Adjust the angle of the light as desired and tighten
the two brass thumb screws on the sides of the fixture
until snug. Do not over tighten. It is best to have all
three fixtures at the same angle.
5. Repeat steps 1 through 4 for the remaining fixtures.
Assembled light fixtures are pictured in Figure 4. Note
the orientation of the lights.
6. Connect each fixture cord to the power cord’s
Hand tighten the waterproof connectors as shown in
Figure 7. Using a cable tie, tie the light kit power cord
to the float opposite the fountain power cord. This
will keep the cord from being damaged by the fountain
and balance the unit properly.
Next, cable tie each fixture cord to the float to protect
each fixture cord as shown in Figure 8.
Fig 7 Check for orange or black oring
Fig 8
7. Upon installation of the assembled unit, connect
your LED light kit to your field installed GFCI
protected outlet and timer.
Note:
Installation of these LED light fixtures on the above
listed aerator/fountain units will ensure proper
submersion of the light fixtures. Each fixture must
be partially submerged in order for lights to operate
properly. Other applications for these fixtures must
provide at least the same submersion to properly cool
the fixture. Operating the fixtures out of water will
damage the LED and void warranty.
A sealing cap is provided for field removal of one light
fixture. If a fixture fails to operate it can be removed
and the cap installed onto the waterproof connector
of the power cord. This will allow you to continue
to operate your light kit with two fixtures while a
replacement fixture is procured.