background image

RGB3C5, RGB6C5 WATERGLOW LIGHTING

MANUAL

884102 / 2021.1.1

10

Kasco Marine

800 Deere Road

Prescott, WI 54021

Contact Us

Phone: 715-262-4488

Fax: 715-262-4487

www.kascomarine.com

[email protected]

REPAIR

Note:

 The LED light fixtures are sealed and do not require any 

physical maintenance other than cleaning. If a fixture fails to 

operate it can be removed and the included sealing cap installed 

onto the waterproof connector of the power cord� This will allow 

you to continue to operate your light kit with two fixtures while a 

replacement fixture is procured. Utilize caution when removing 

the shrink tube from the connector.  Only perform this removal/

replacement with all equipment disconnected from the power 

source� 

Any required repairs must be performed by Kasco Marine� Any 

alterations or changes made to Kasco units by an unauthorized 

source will void the warranty. This includes tampering with the 

unit, power cord, and/or control box. 

A physical Kasco Repair Form must be included with any equip-

ment sent to Kasco or an Authorized Repair Center. This form 

can be found under the 

Product Support

 section of 

kascomarine�

com

. If no Repair Form is available, include your name and 

physical address for return delivery of the repaired Light Kit and 

a daytime phone number and/or e-mail address for correspon-

dence regarding the warranty claim� 

Note:  Visually inspect the power cord for any cuts, rodent 

chews, etc. to determine if it should be included in the repair 

shipment� The cord may be needed by the shop to diagnose the 

failure�

Once warranty coverage has been established, the equipment 

may be sent to any Kasco Authorized Repair Center or to Kasco 

at:

NON-WARRANTY REPAIRS

Most failed equipment can be repaired at substantially lower 

costs than replacement with new� If your light kit requires repair 

and is no longer covered under warranty, please contact Kasco 

Marine or your local distributor for available options. Please ship 

according to the instructions above.

•  Kasco Marine does estimates on repairs at the request of 

the customer� The request for estimate should be included 

in the letter that accompanies the returned unit and must 

include a daytime phone number and/or e-mail address� We 

will contact the customer with a total after the unit has been 

evaluated, but before the work is performed.

• 

All estimates that are rejected for repair will be destroyed 

unless otherwise directed by the customer. Rejected 

equipment can be returned at the customer’s expense for 

shipping and handling charges�

Billing: 

All non-warranty repairs will be returned and billed to the cus-

tomer unless otherwise directed� Kasco Marine accepts Visa 

and MasterCard credit card payments� Kasco Marine will call for 

credit card information upon completion of the estimate at the 

customer’s request.

Please see the 

Product Support

 section of 

kascomarine�com

 

for more information about warranty and repairs� Contact Kasco 

Marine at the number above or [email protected] for ad

-

ditional information and your closest Authorized Repair Center.

Back to Contents

Summary of Contents for RGB3C5














Reviews: