![background image](http://html.mh-extra.com/html/kasco/2400evfx/2400evfx_owners-manual_657113010.webp)
10
The
Redwood
nozzle uses the 3 self tapping screws to
attach over the pump housing and the Y Insert must be
installed.
Model
Height
Width
2400EJF
n/a
n/a
3400EJF
n/a
n/a
4400EJF
4.9 m
1.5 m
The
Spruce
nozzle uses the three self tapping screws
to attach over the pump housing and the Y Insert must
be removed.
Model
Height
Width
2400EJF
n/a
n/a
3400EJF
n/a
n/a
4400EJF
4.1 m
3.0 m
The
Birch
display does not use a nozzle or bolt. It is
the fountain unit running without any nozzle and al-
lows for the best fl ow rate and oxygen transfer!
Model
Height
Width
2400EJF
n/a
n/a
3400EJF
n/a
n/a
4400EJF
2.6 m
1.8 m
Installation Instructions
STEP ONE
Use the ropes to position the Unit in the desired loca-
tion in the pond/lake (secure the cord near power
source to prevent it from being dragged into the wa-
ter). Anchor the ropes or secure them to the shoreline
so the ropes are free of slack, but not tight. To prevent
twisting of the unit due to torque, you should place
the anchor at least 3m from the fl oat for each meter of
depth (Ex. A 3m deep pond would require an anchor
9m horizontally from the fl oat.) For ease of removal,
you may choose to keep at least one anchor within
reach from shore, just below the water’s surface.
Correct Anchoring
Incorrect Anchoring
STEP TWO (ALTERNATE INSTALLATION)
In ponds where the water level fl uctuates signifi cantly,
you may need to suspend a small weight (30cm of
2.54cm galvanize pipe works well) at the mid-point of
the rope to take up any slack as the water level drops.
The weight should be light enough so the Unit can rise
as the water level rises. This can also help hide ropes
by sinking them further below the surface.