Kartsana JUPITER TG-880 C, Instruction Manual

Page: 17 / 32

OPERATION AND HANDLING OF
CART TG-880-C COMPACT STRETCHER
14
2.2.12- Installing the cart on the ambulance’s stretcher holder
Kartsana recommends that the anchoring of the stretcher-cart to the
ambulance is carried out using Kartasana rail R-450N and R-414, which have
been specifically designed for this purpose.
Move the cart to the ambulance platform and place the front leading wheels (wheels
100 mm in diameter), on the stretcher holder and if the platform incorporates the
kartasana rail, place the aforementioned leading wheels on the outside of the rails.
Then actuate the front wheels control to fold the front wheel (blue control) and insert
the stretcher into the stretcher holder up to the rear wheels. At this point, activatethe
rear wheel control (orange) to Fol. It.
After actuating the orangecontrol, part of the weight of the rear end of the
stretcher must be supported, and so it will be necessary to hold it firmly with
both hands.
Once the aforementioned process has been executed in full, the cart can be inserted
completely into the stretcher holder, until it locks in place at the front and rear. The
Kartsana rail anchors the stretcher-cart at the front by means of two anchoring points
and one anchoring point at the rear (see the figures below) These anchoring points
prevent the stretcher-cart from overturning in the event of an accident. If the Kartasana
rails are not used, it is recommended that the anchoring of the front section of the
stretcher-cart is carried out through the ends of the stretcher’s rear bar as shown in
the diagram.
Anchoring
point 1
Anchoring
point 2